毛细管电泳-电化学发光法测定石蒜鳞茎中的石蒜碱

建立了毛细管电泳-电化学发光(CE-ECL)检测石蒜碱的方法。探讨了检测电位、分离缓冲液pH和浓度、分离电压、进样电压及进样时间等因素对石蒜碱分离检测的影响。在最佳实验条件下,石蒜碱含量在0.03~2μg/mL范围内与其峰面积呈良好的线性关系,相关系数为0.9995,检出限为0.005μg/mL(S/N=3)。对0.8μg/mL石蒜碱进行7次平行实验,其迁移时间、峰高和峰面积的RSD分别为1.7%,5.2%和5.6%。方法应用于石蒜鳞茎中石蒜碱的测定,加标回收率为92.2%~98.6%。     

气相色谱法分析植物油中的脂肪酸

确定了植物油脂肪酸进行气相色谱分析前合适的样品处理步骤及条件和最佳的气相色谱分析方法,对6种食用植物油进行了处理分析。样品前处理主要步骤及条件:约0.045g样品,先加入萃取剂苯-石油醚(2:1,V/V)2mL;然后用2mL 0.4mol/L KOH-CH3OH溶液作酯化剂,于60℃酯化30 min后,再用1.5mL 15%BF3-CH3OH(w t%)溶液作酯化剂,于50℃酯化40 min。由食用植物油样品甲酯化后进行GC分析可知,各类植物油中的脂肪酸均能得以甲酯化进行准确的定性、定量分析。     

聚阳离子糖缀物氢键诱导TPPS手性聚集

利用原子转移自由基聚合(ATRP)方法制备了亲水性嵌段聚合物聚乙二醇-b-聚甲基丙烯酸N,N-二甲氨基乙酯(PEG-b-PDMAEMA),并通过季铵化反应,得到侧链接枝不同单糖分子(葡萄糖、半乳糖、甘露糖)的聚阳离子糖缀物PEG-b-P(DMAEMA-co-DMAEMA-Sac)(Monosaccharide).研究了该聚合物与5,10,15,20-四(对磺酸基苯基)-卟啉(TPPS)在水溶液中的复合自组装行为.研究结果表明,TPPS在该组装体中以J-聚集体形式存在且显示超分子手性特征.手性信号的产生是聚合物侧链糖单元C(4)和C(5)上的羟基与TPPS通过非共价键——氢键相互作用的结果,因此手性信号方向应与糖单元构型有关.通过对比单糖构型发现,具有(4S,5R)构型的糖单元可诱导TPPS产生424 nm正Cotton效应和490 nm负Cotton效应的聚集体,具有(4R,5R)构型的糖单元可诱导TPPS产生424 nm负Cotton效应和490 nm正Cotton效应的聚集体.     

硫酸铈铵对三角褐指藻岩藻黄素含量的影响及转录差异研究

利用血球计数法测定藻密度,研究不同浓度硫酸铈铵诱导子对三角褐指藻细胞生长的影响。采用高效液相色谱(HPLC)测定经不同浓度诱导子处理后三角褐指藻岩藻黄素的含量。通过荧光定量PCR研究岩藻黄素生物合成途径中相关基因转录差异,并利用SAS9.0统计软件对荧光定量PCR结果做主成分分析。结果显示:在一定浓度范围内硫酸铈铵(0.2~1.6 mg·L-1)抑制三角褐指藻细胞的生长。HPLC结果表明:随着硫酸铈铵浓度的增加,岩藻黄素含量呈先上升后下降的趋势,当硫酸铈铵浓度为0.2 mg·L-1时,岩藻黄素含量最高,达1.28 mg·g-1DW,比对照组提高了60%。定量PCR分析结果表明,硫酸铈铵浓度在0.2 mg·L-1时,岩藻黄素生物合成相关基因玉米黄素环氧酶基因(zep)、八氢番茄红素合成酶基因(pys)、ζ-胡萝卜素脱氢酶基因(zds)、番茄红素β-环化酶基因(lcyb)、胡萝卜素异构酶基因(rtiso)和八氢番茄红素脱氢酶基因(pds)转录水平与对照组相比极显著提高(P<0.01),与岩藻黄素含量变化相一致。主成分分析(PCA)结果表明:这些基因与岩藻黄素生物合成显著相关,其中,lcyb基因和pds基因对岩藻黄素生物合成贡献率最大。     

核-壳结构TiO_2@Pt复合纳米颗粒修饰的葡萄糖生物传感器

制备了核-壳结构的TiO2@Pt复合纳米颗粒,并修饰于恒电位沉积的普鲁士蓝-壳聚糖(PB-CS)杂化膜表面,以固定葡萄糖氧化酶。由于TiO2@Pt复合纳米颗粒的引入显著增大了传感器的导电性和酶的固载量,同时CS的掺杂,防止了PB的泄露,使得传感器对葡萄糖具有较好的催化作用。该传感器在1.2×10-6~1.1×10-3mol·L-1范围内,响应电流与葡萄糖浓度呈良好的线性,相关系数(r)为0.998 6,检出限(S/N=3)达到4.0×10-7mol·L-1,灵敏度为13.31 mA·mol·L-1·cm-2。对0.3 mmol·L-1的葡萄糖标准溶液连续检测5次,其相对标准偏差为3.8%。     

Synthesis,Structure, and Properties of O6‐Corona[3]arene[3]tetrazines

O₆‐Corona[3]arene[3]tetraazines, a new class of macrocyclic compounds, were synthesized efficiently in a one‐pot reaction from the nucleophilic aromatic substitution reaction between 1,4‐dihydroxybenzene derivatives and 3,6‐dichlorotetrazine in warm acetonitrile. In the crystalline structure, the resulting macrocycles adopt highly symmetric structures of a regular hexagonal cavity with all bridging oxygen atoms and tetrazine rings located on the same plane with phenylene units orthogonally orientated. The constitutional aromatic rings are able to rotate around the macrocyclic annulus, depending on the steric effect of the substituents and temperature, in solution. The electron‐deficient nature revealed by cyclic voltammetry, differential pulse voltammetry, and characteristic absorbances at a visible region show the O₆‐corona[3]arene[3]tetrazines to be suitable macrocyclic receptors for electron‐rich guests.     

Comparative study on structure and properties of titanium/silicon mono‐ and co‐doped amorphous carbon films deposited by mid‐frequency magnetron sputtering

The titanium/silicon mono‐ and co‐doped amorphous carbon films were deposited by mid‐frequency magnetron sputtering Ti target, Si target, and Ti80S20 alloy target, respectively. The effects of doped elements on the composition, surface morphology, microstructure, and mechanical and tribological properties of the films were investigated. The results reveal that the ratio of sp³ and sp² carbon bonds of the films is regulated between 0.28 and 0.62 by a combination of Ti and Si dopant. The addition of small amounts of silicon leads to an increase in sp³ bonds and disorder degree of the sp² carbon. The co‐doped film exhibits significantly superior friction performance than the mono‐doped films. The ultra‐low friction (μ < 0.01) was achieved under a load of 2 N in ambient air with 40% RH. By comparing to the mono‐and co‐doped films, it is thought that the sp³/sp² ratio of the films may play a key role for the superlow friction. Copyright © 2013 John Wiley & Sons, Ltd.     

Genetic profile characterization and population study of 21 autosomal STR in Chinese Kazak ethnic minority group

Short tandem repeat loci have been recognized as useful tools in the routine forensic application and in recent decades, more and more new short tandem repeat (STR) loci have been constantly discovered, studied, and applied in forensic caseworks. In this study, we investigated the genetic polymorphisms of 21 STR loci in the Kazak ethnic minority as well as the genetic relationships between the Kazak ethnic minority and other populations. Allelic frequencies of 21 STR loci were obtained from 114 unrelated healthy Kazak individuals in the Ili Kazak Autonomous Prefecture, Xinjiang Uigur Autonomous Region of China. We observed a total of 159 alleles in the group with the allelic diversity values ranging from 0.0044 to 0.5088. The highest polymorphism was found at D19S433 locus and the lowest was found at D1S1627. Statistical analysis of the generated data indicated no deviation from Hardy–Weinberg equilibriums at all 21 STR loci. In order to estimate the population differentiation, allelic frequencies of all STR loci of the Kazak were compared with those of other neighboring populations using analysis of molecular variance method. Statistically significant differences were found between the studied population and other populations at 2–7 STR loci. A neighbor‐joining tree was constructed based on allelic frequencies of the 21 STR loci and phylogenetic analysis indicates that the Kazak has a close genetic relationship with the Uigur ethnic group. The present results may provide useful information for forensic sciences and population genetics studies, and can also increase our understanding of the genetic background of this group. The present findings showed that all the 21 STR loci are highly genetically polymorphic in the Kazak group, which provided valuable population genetic data for the genetic information study, forensic human individual identification, and paternity tests.